In cs3 photoshop why does my marquis not let me make it into a stroke

Troubleshooting Marquee Selection Issues in CS3 Photoshop: Why Can't You Convert It into a Stroke?

Are you experiencing frustration when trying to convert your marquee selection into a stroke in Adobe CS3 Photoshop? This common issue can be quite vexing, especially if you've spent considerable time carefully selecting the area of interest. In this article, we'll delve into some possible causes and offer practical solutions to help you overcome this problem.

Causes for Marquee Selection Not Converting into Stroke

1. Selection Type: Ensure that your marquette (marquee) selection is set to 'Regular' or 'Layer Mask' mode before attempting to convert it into a stroke. If the selection type is anything else, such as 'Inverse,' 'Feathered,' etc., you won't be able to apply any effects like Stroke.

2. Selection Edge: Check whether your marquee's edge is 'hard' rather than 'soft.' A soft-edged selection might not work well with certain operations including strokes.

3. Layer Blending Mode: Sometimes, layer blending modes can interfere with the ability of a stroke to be applied properly - try changing this setting if necessary (Edit > Preferences > General).

4. Stroke Panel Settings: Make sure that you have enabled 'Show Stroke' in your preferences under 'Type' and also make sure that there are no other active layers or objects above/below which could potentially override the visibility of stroke.

Troubleshooting Steps

1. Check Selection Type & Edge:

- Go to Select > Convert to Smart Object (Ctrl+Shift+F9).

- Then go back into regular mode by clicking on 'Layer' at top toolbar then select 'Normal' from drop-down menu under 'Layers panel'.

2. Try Inverting the Selection

- Hit Ctrl/Cmd + Shift + I or go to Edit > Select > Invert.

- If this doesn't work, try selecting a small area inside your original selection and see if you can apply stroke now.

3. Check Layer Blending Mode & Stroke Panel Settings:

- Go to Layer > blending options (or double-click on layer thumbnail in layers panel).

- Under 'Stroke' tab make sure 'Show' is checked.

4. Reset CS3 Photoshop Preferences

- Quit Adobe Photoshop completely by going Window>Quit or Cmd+Shift+F10 for Mac, then hold down Shift while launching it again.

In conclusion, converting a marquee selection into a stroke in CS3 Photoshop should be relatively straightforward if you've followed these simple troubleshooting steps. Remember to always double-check your selection type and edge before attempting any operations like this - sometimes the solution lies in the most obvious places! If you continue experiencing issues after trying out all of above solutions, feel free to leave a comment below so we can further investigate together.

By following these tips and tricks, you'll be able to overcome common marquee selection problems such as converting them into strokes with ease. Happy editing!

In cs3 photoshop why does my marquis not let me make it into a stroke